V. Senthilkumar

Abstract

Engineering is mostly concerned about customers' satisfaction. Initial stage for every production processes is DESIGNING. Without design stage an industry cannot run profitably. It is the only activity through which a designer can express his ideas into a real product. Itcovers the major portion oftime and cost ofproduction. Hence our projectfocus on modeling, to reduce the time and cost. Transfer of energy is the basic for any action. For this, mainly used industrial component is shaft. Couplings and joints act as a language between two shafts. Based on the diameter ofthe shaft the dimensions of the coupling vary. Hence there is a need to remodel the component as per the new dimension. To reduce the time of modeling, this project deals with automatic generation of Oldhaт coupling. This paper can be further enhanced by following the same procedure to customize the automatic generation of any component as per the requirement of the industry.

Keywords-